Track intelligence, spotlight breaking news
Blogs
16
2021-07
Timing belt tooth surface wear solution
1. The load is too large. 2. The belt tension is too large. 3. Mixed with abrasive powder layer. 4. Rough gear teeth. Solution: 1. Improve the design. 2. Adjust the belt tension. 3. Improve the environment and increase the protective cover. 4. Polish the gear teeth or replace the pulley.
16
2021-07
Synchronous belt tooth breaking solution
1. Jumping teeth. 2. Passive mechanical accident load increases. Solution: 1. Check the design. 2. Adjust the appropriate tension. 3. Increase the diameter of the pulley. Increase the number of teeth. 4. Eliminate passive mechanical failures
16
2021-07
Timing belt with back rubber wear and crack solutions
1. The rotation of the outer tension wheel is blocked. 2. The positioning of the outer tension wheel is misaligned. 3. It hits the frame of the machine. 4. Long-term low temperature state. Solution: 1. Repair or replace the tensioner bearing. 2. Correct the position of the tension wheel. 3. Check and correct the mechanical parts. 4. Improve the ambient temperature.
16
2021-07
With adhesive softening solution
1. High temperature 2. The tensioner stops rotating. 3. Stick oil. Solution; 1. Improve the ambient temperature. 2. Check and adjust the tension wheel. 3. Do not stick to oil or change the oil-resistant timing belt
16
2021-07
Belt longitudinal cracking solution
1. The timing belt runs beyond the edge of the pulley. 2. The timing belt is rolled on the side wall of the pulley. Solution: 1. Adjust the position of the pulley. 2. Enhance the rigidity of the bearing and fix it firmly.
16
2021-07
Fracture solution for tensile body part
1. Incorrect loading and unloading of the timing belt. 2. Mixed with debris or sharp residue. Solution; 1. Correctly load and unload the timing belt. 2. Improve the environment. Increase the protective cover.